Tracrac IM TracRac Toolbox Mount Kit Manual de usuario descargar pdf (Pagina 2)

994 Jefferson Street, Fall River, MA 02721

Tel: 800-501-1587, 508-677-4130, Fax: 508-677-4136

(REV B) 06/11/02 Page 2 of 4

3) Your goal is to position the Mount Kit beneath your toolbox in the correct location, so the box can be mounted

to the Base Rails. Start by measuring the width between the Base Rail inner T-Tracks. (See Fig 1) Hook the

tape measure on the outer edge of the driver’s side inner T-Track and measure to the innermost edge of the

passenger side T-Track (this is Measurement A: mark it down below).

4) Take your toolbox and measure the width of the box’s belly (Measurement B) (See Fig 2)

5) Use the chart in Figure 2a to calculate where to drill the holes in your toolbox.

6) A minus B equals C & C divided by 2 equals D

Figure 2a

Record Measurements Here

Measurement A:

minus

Measurement B:

Equals C:

Divide C by 2:

To get Measurement D:

WING

KNOB

Figure 2

FLAT WASHER

DRILLING

LOCATION

BOX’S BELLY

LOCK NUT

INNER TOP

T-TRACKS

BASERAILS

SIDE T-TRACK

Figure 1

DRIVER’S SIDE

OUTER EDGE

PASSENGER’S SIDE

INNER EDGE

1 2 3 4

Sin comentarios

Tracrac IM TracRac Toolbox Mount Kit Manual de usuario Pagina 2