
TracRac Inc. 994 Jefferson Street, Fall River, MA 02721-4893 • 508-677-4130
4. Insert the J-Hooks with Neoprene Strips through the
Assembly Slots at the base of the Corner Bracket. Then
insert 2 Brass Nuts into the opening of the J-Hook clips.
Thread each screw approx. 1/4 in. into the J-hook’s brass
nut. (Do not completely tighten screws) Repeat for each
Corner Bracket, (2 hooks for each Bracket).
5. Now you’re ready to attach the Crossbars (see Shim
Installation, page 6, if shims are required on front and
rear racks). Insert the heads of four 1 1/2” T-Bolts into the
Crossbar Slot on the bottom of each Crossbar (the bottom
is the side with the Flat Recess)
Bolts to the left side and 2 T-Bolts to the right.
2. Fit the Rubber Strip on the lower edge of each Corner
• On 2000+ Ford 150 Econoline vans.
• If using the Gutter Spans
3. Insert 2 (5/16” x 1 3/4 ” long) Socket Head Cap Screws
through the Lock Washers and then into the holes in each
6. Attach a Corner Bracket assembly to the Crossbar by
inserting the T-Bolts through the two holes in the Corner
Bracket. Partially tighten and secure with the Self Lock-
ing Nuts – enough to hold the Corner Bracket in place.
Repeat for each of the remaining three Brackets.
7. Slide the Crossbar Tiedowns onto the Crossbar by insert-
ing the T-Bolts into the top Crossbar Slot.
Brass nut fits into J-hook
Comentarios a estos manuales